a.The vehicle spraying part should be thoroughly cleaned to achieve no rust, no water, no dust, no oil, no wax traces, clean afterwards, dry thoroughly with the wind.
b.Cover areas that do not need to be covered with waste newspapers (including exhaust pipe, body, engine, water tank, spring, air conditioner, condenser, frame number, etc.).
c.Open the bottle cap, insert the special airbrush for the factory and shake the product for about 2 minutes so that the contents of the tank can be mixed evenly. Followed by 0.60-0.80 Mpa of compressed air, then sprayed evenly about 25-50cm from the sprayed surface.
d.It is recommended to spray three time to prevent flow marks and sagging, not to spray too thick, there must be between each spraying foe a certain time interval, it is better to be about 15 minutes apart at normal temperature. After the first spraying is finished, there are holes oil, cracks, and joints must be sprayed. The thickness is more than 2mm and the soundproof and rust prevention effects are obvious.
e.After drying, seal, install and complete the construction.